1/7
Model Overview & Print Notes
This is a watch I designed for a wedding based on a cheap watch I bought in a dollar store. I really like the simplistic design, it prints quickly and you can easily customize the colors based on your style!
I never uploaded this design because it can be hard to source the right watch to fit this 3D print, but I think it is a quite nice exclusive 'thank you' model for anybody who votes for me!
Things you will need:
A donor watch (most cheap watches use the same movement)
- The crystal diameter should be about 38.5mm
- The stem length (center to inside crown) should be about 22mm when pressed in
Two M2*4mm countersunk screws
Disassembly of the watch is different per watch but mostly not very hard, just be careful.
To assemble the watch
1. Snip off the supports from the ring
2. Place the movement and press on the hands (make sure of the orientation and possibly bend them up to clear the dial and each other)
3. Place the dial and the crystal in the ring
4. Place the stack in the case and screw it tight from the back
Happy printing!
Rossero
💬CrealityCloud Community Comments(...)
★CrealityCloud Original Reviews