Upgrade your FPV quad with these durable TPU mounts! This set is designed to protect your expensive electronics and secure your HD camera during flights and crashes.

Printed in flexible TPU, these parts are designed to absorb impact energy, saving your carbon fiber frame and electronics from damage.

Files Included:

1. Combo HD Camera & Antenna Mount (Front/Top)

Dual Function: Features a standard 3-prong GoPro interface to mount your Action Camera (GoPro, DJI Action, RunCam Thumb, etc.) and a vertical tube holder for your VTX or RX antenna.
Clean Build: The bridge design allows the mount to sit over the top plate, clearing screws or straps.
Vibration Dampening: The TPU material helps reduce Jello in your HD footage by absorbing high-frequency vibrations from the motors.
2. Rear Antenna / Tail Mount

Secure Fit: Designed to hold your Crossfire/ELRS T-antenna or video antenna securely at the rear of the drone.
Crash Protection: Acts as a bumper for the rear of your frame, protecting the carbon fiber from delamination during tail-first crashes.
Angled Design: Keeps the antenna at the optimal angle for signal penetration.
Print Settings (Recommended for TPU)
Material: TPU (95A recommended).
Infill: 100% (It is highly recommended to print FPV parts solid for maximum durability and crash resistance).
Walls/Perimeters: 3 or 4.
Speed: Slow down to 20-30mm/s for better layer adhesion and finish.
Supports:

Camera Mount: Yes, supports are likely needed under the GoPro tabs and the bridge arch.
Rear Mount: Orientation dependent, but usually minimal supports required.