1/9
Model Overview & Print Notes
An active dryer add-on for the CFS,
The Polymaker Polydryer can be connected to the CFS with an adapter.
The lid still closes and locks in place with 2 sliding clips.
When the dryer is in use, the humidity drops to around 12%.
This enables you to print moisture-sensitive materials.
The holes in the side pieces should be tapped to M5.
You would need the following screws.
- 2x DIN7991 M5x10
- 2x ISO 7380 M5x10
Or you could just glue it together for slightly less convenience.
I added 2 different funnels.
The normal one is flush with the bottom of the CFS, but since my CFS is on a riser like mine, I also added a higher version.
💬CrealityCloud Community Comments(...)
★CrealityCloud Original Reviews