This 3D-printed SD card holder is shaped like the iconic macOS folder, bringing a touch of digital charm to your physical workspace. Whether you're a photographer, maker, or just a fan of neat aesthetics, this little folder keeps your SD cards safe, stylish, and always within reach.

Pop the digital world into the real one – because who says your desk can’t look like your desktop?

Parts

• 2x 10x2.5mm magnets (I bought 10x3mm ones that turned out to be 10x2.5mm when measured)
• A small length of iron wire (or similar)

Assembly

Pause the print before the magnet holes are closed. The exact layer is based on your layer height settings. For example; when printing with a 0.16mm layer height, the pause should be at layer 22. When you are using my 3MF file, the pause should be included automatically. Then you can put in the magnets.

Make sure to put the magnets in at the right polarity. One of the magnets should be placed with the north pole down the bed, while the other one should have the south pole placed on the bed.

When the print is finished you can join both halfs together by sliding a piece of iron wire (or similar) into the hole on the side of the folder.

Material

Polymaker PolyTerra™ PLA Ice Blue