Pop-On Cap Propeller – Snap & Spin with Style!

Ready to take your hat game to new heights? This upgraded Cap Button Propeller is a whimsical, low-effort, high-fun accessory that instantly transforms any standard baseball cap into a spin-tastic conversation starter.

💡 Key Improvements Over the Original:

• Snap-fit design – No clips or hinges! Just pop it on and off your cap's button with a gentle press.
• 3 propeller styles included:
  • Classic Flatblade – clean and minimal
  • Swept-Back Aero – dynamic and stylized
  • Chonky Stubby – comically short for max silliness

🎨 Dual-color recommended! Print the propeller in black and the hub in white or a fun accent color for a sharp contrast.

🖨️ Print Specs (for one full setup):

• Material: PLA or PETG
• Layer Height: 0.22 mm
• Infill: 15–20%
• Supports: Minimal, needed for underhangs (adds ~1.26g)
• Filament Used: ~8.65g / 2.85m total
• Estimated Print Time: ~52 minutes

🧢 Assembly:

• Press-fit the base over the top button of most 6-panel baseball caps
• Insert your favorite propeller style into the hub
• Give it a flick — it'll spin freely with just a breeze or a nod!

Perfect for costumes, parties, or bringing a bit of cartoon whimsy to your daily stroll.