This frame is extremly aerodinamic & efficient!!! 

It is optimiced so much that I reached a flight time of 8.5 minutes and 75 km/h (46 m/h) (*only in perfect conditions…)

This is a very light & aerodinamic combination of a frame, a canopy for the camera and attachable prop guards!

You can fly ultra light, or attach the propeller guards with only 3 screws

I made and tested over 18 versions and this is up to now the best one!

There is a normal frame and a ultra light one, the only difference is that the normal one is a bit more stable…

But the difference is pretty hard to spot just looking at the pictures…

I made it for my Betafpv meteor 75 pro. For this model it fits perfectly! But I am sure it will also fit for similar models!

I printed it with PLA, but you can use stronger filament, just keep in mind that no metter which filament you use if you keep crashing harder and harder the propeller guards are not indestructible, so like all other propeller guards at some point they will break.

Nonetheless I made them as sturdy as I can! I already crashed hard a few times and they are still in perfect condition!

If you are thinking of using other filaments here some advice:

• Use a horizontal stiff filament (for ex. PLA CF) for the main frame of the drone and the prop guards, so it doesn't flex too much.
• Use a filament with good layer adhesion for the canopy, so the thin parts don't break.