28/8/23 Added step file for battery holder to aid with remixes

2 versions, a single battery and a triple battery version. Prints vertically, no supports

Important note on scaling

As the fit of the battery is so precise I would advise printing the single version first to test fit. 

Mine were printing at 100% on a Prusa mk2s. However most people seem to be getting best results at 105%. I've now added the “bestfit” versions that are pre-scaled to 105%
 

** Remember to de-burr any edges which may affect the fit.

Also note that I printed all of mine in PETg, which is more flexible than PLA, and therefore you may need to upscale slightly to achieve a good fit in PLA