This is a remix of the "Cascadia Organizer" board game insert by Aaron.
- Thinned the walls on the bag tray and added a logo deboss
- added a snap-fit box for the pinecones with a logo deboss (or optionally a different coloured inlay using the file provided as pictured)
- flattened the bottoms on a few prints to make printing easier


These files are optimized for 0.8 nozzle and 0.32 layer height (but should work fine with whatever).

Magnets (optional) to hold the cone tray in place are 2x30mm.

If you want to print the cone tray lid with a different coloured inlay (pictured):
0. Either use a 0.32 layer height, or else modify the inlay file to be exactly “1 Layer” in height
(You might be able to get away with just scaling the Z for the inlay and leaving the lid alone if your layer height is close to 0.32)
1. Flip the inlay text 180 degrees around X and centre it, print with no brim
2. Keep the bed hot! Set your printer to heat up right after the inlay print is done
3. Remove the outer line around the print without removing the build plate (line is used for centering in Cura and other slicers)
4. Flip the cone tray lid 180 degrees and centre it, print with no brim right over the existing inlay on the build plate

Ironing in Cura will make these parts look good, but I am too lazy/impatient and didn't bother.