Remix of a coffee mug model to serve as an air-plant holder. It's been scaled down from the original model and has a magnet on the back so that it can be attached a refrigerator, cubicle, etc. Obviously it can be printed and used as a generic magnet as well.

The back of the mug has a cut-out for a 6.3mm neodymium magnet (available at most craft stores).

Print instructions

Magnet Adhesion

Completed prints were cleaned, and the magnet was attached with a two-part epoxy.

After the epoxy cured, the mugs were placed in a cold acetone vapor chamber for 30 minutes.