We've created a test print to calibrate your settings printing in ABS/ASA.

The test print contains

• 5mm Dowel pin hole top to bottom 
  • This is a 5.3mm hole to compensate for shrinkage
• 5mm Dowel pin hole side to side
  • This is a 5.3mm hole to compensate for shrinkage
• M3 Hole including a heatset insert (M3 X D5.0 X L4.0)
• M3 through hole
  • This is a 3.3mm hole to compensate for shrinkage
• 0.4mm Single wall to verify .4 print settings
• Overhang / bridge test in the bottom
• Overhang test up to 70°
• X and Y lettering to check for ringing.
•  

To test this print you need to use the following settings

• First layer 0.25mm
• Other layers 0.2mm
• Wall thickness 0.4mm
• Walls - Up to you
• Top / Bottom - Up to you
• Infill - Up to you

Recommended filament

• ABS