Greetings, everyone!

I'm thrilled to present my entry for the Dice Towers contest: The D20 dice tower!

To ensure seamless printing, I've made modifications to the numbers so that no supports are required. You can easily remove any residual supports with a razor blade after printing.

The maximum diameter of the dice accommodated is 30mm, more than enough for standard-sized D&D dice (bigger 34mm D20 exist so check beforehand).

Example print details: 30mm layer height, 10% gyroid infill, with each part taking approximately 6 hours and 30 minutes to print. Glued the two parts using Tamiya patty, i will post the painted version in a few days.

Please note: The images depict an earlier version where the dice were not ejected quickly enough. This issue has since been resolved.