Model Overview & Print Notes

**A fridge notepad with many features.** It comes with a little flag, so you don’t forget to get your groceries. It uses common tear-off note block paper and is refillable indefinitely. It is equipped with a pencil case, extra magnets to pin your notes and a stencil. You can also mount this with wall-mount tape if your fridge is nonmagnetic or you want to place it elsewhere. Single and multi-color printing models are included as STL and 3MF! They work with all current and usual multi color setups. **What you need** A 90 x 90 mm (3.5 x 3.5 inch) note block. Non-sticky and tear-off. 10 x 2 mm magnets (10 pieces). A pencil with the maximum diameter of 12 mm. The 3d printed parts. **Instructions (go along with the pictures)** Print all parts. Glue the magnets in. Tear off a 10 – 20 mm thick piece of your note block. Insert the last 2-3 pages into the slot and slide the block in from above. Attach your extra magnets, insert the pencil, stencil and flag. Place the assembly on your fridge. Enjoy! The stencil has a extra edge that helps as handle and orientation help that is supposed to placed on top of the block for alignment when drawing. The design has 6 back magnet holes. Depending on the strength of your magnets you can use less. **Print settings** Required build volume: 120 x 120 x 100 mm Material usage: 90 g Material: PLA Print direction: files are rotated correctly Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Infill: 15% Build plate adhesion type: none