Model Overview & Print Notes

**RAMA | Kitchen rail, hook & planter** Here is a complete collection of accessories for kitchen rails. This **FREE** set includes **wall brackets** for Ø18mm or 3/4inch wooden rails, plus **hanging planters** and **hooks**. (The wall brackets work with Ø4 to 5mm screws, or #8 - #10 screws, and 1" or 30 to 40mm anchors) On the rail you can also mount: - a **[magnetic knife rack](https://than.gs/m/1352296)** - a **[cookbook or ipad shelf](https://than.gs/m/1352297)** - a **[dishsoap and spong holder](https://than.gs/m/1352300)** - a **[drip tray](https://than.gs/m/1352303)** to dry your cutlery - a **[spice rack](https://than.gs/m/1352306)** - a **[towel holder](https://than.gs/m/1352323)** You can get the wooden dowels/rails on Amazon here: For the US (Ø3/4 inch): https://amzn.to/4klPfVE For Europe (Ø18mm): https://amzn.to/3T5q4dW **3D PRINT SETTINGS:** All STL files are all already oriented properly. No need for supports, or brim. The **hangers** print on their side and **don't need support**, even for the overhanging part. **Layer height:** 0.2mm/layer **Wall line count:** 2 **Infill:** 15 to 20% **Build adhesion type:** None **Supports:** None To **mount the wall brackets and wooden rail:** - mark locations for the holes on your wall, every 40 to 50cm or so depending of the length of your wooden rail. So for a 1m or 40" rail you'd have 3 brackets. Leave about 5cm or 1.5" of wooden rail sticking out past the brackets at both extremities. - drill holes in your walls at the right diameter for your anchors (diameter about Ø3/16" or Ø5mm, 30 to 40mm deep). - place the inserts in the wall - fix the "dovetail" pieces on the wall with the scews - slide some wall brackets on the wooden rail - then place the rail parallel to the walls and slide the brackets onto the dovetails. (or you could first put 1 bracket onto 1 dovetail, slide the wooden rail inside, and THEN put the additional 2 brackets on the rail and slide them onto the dovetails. Maybe easier that way...).