Summary

A toothbrush holder for oral-b. Fits on the charger. Can be marked with the colored rings.

2018-09-15:
-Openscad file added. You can modifiy the openscad file to match the holder to the calibration of your printer. You can also create a small pin (a miniumum holder for a single brush) to check the fitting before you print the complete holder.

increased the number of faces to get smoother print
added a variant which should fit more loose to the toothbrush as well as to the charger (_loose.)

Print Settings

Printer Brand:

Wanhao

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Wanhao Duplicator i3 V2</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.1</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>40%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Heads break easily if the infill settings are not matching the design. Check the upmost layer in your slicer below the heads before printing to ensure enough structures printed as a base for the heads. Change infill geometry or infill percentage in case of improvement needed.  </p></div>