Adjustable Dual Watch Display

Upgrade your desk setup with this mechanical watch stand.
Display up to 2 watches and tilt them to the angle you like by twisting the knob (22.5° steps).

Fits most watch models. All of the 7 parts print without supports.

⬆️ A fan of Casio G-Shock watches? Get the G-Shock version.

Quick facts

• Size: 15 x 8 x 11 cm (5.9 x 3.1 x 4.3 in)
• Parts: Base, Pillar Left, Pillar Right, Drum Right, Drum Left, Knob, Gear, Spring, Clip (3 pieces)
• Supports: none (please refer to image above for optimum print orientation)
• Multi-material/AMS: not required
• Material: any
• Walls: 3+ for strength
• Print time: about 5 hours
• Filament: about 150 g
• Assembly: snap-fit, glue.

Assembly steps (please refer to images above):

1a. Join Drum Right and Drum Left using 2 pieces of Clips as shown. They should snap together nicely, so no glue is necessary for this.

1b. Connect Gear to the shaft of Drum Right as shown, with the Gear teeth facing the shaft. Apply some glue to the 2 protruding tabs of the shaft before sliding the shaft all the way into Gear.

1c. Connect the other side of Gear to Knob as shown. Apply some glue to the end face of Gear before sliding it into Knob.


Do not use glue for all of Step 2

2a. Insert Clip and Spring into Pillar Right as shown. Clip will securely snap into place, while Spring will sit loosely in the pocket inside Pillar Right.

2b. Place the Drum assembly (from Step 1) into the cylindrical channel in Pillar Right as shown. Make sure Spring sits right underneath teeth of Gear as shown.

2c. Join Pillar Left to Pillar Right together as shown. They should snap together nicely, so no glue is necessary for this.


3a. Snap the bottom of Pillar assembly (from Step 2) to the hole in Base as shown. They should snap together nicely, so no glue is necessary for this.

end of instructions