Small Dachsund dog with a springy body and wobbly legs

Two length versions (76 and 96mm)

Optional models for a multicolor print

If you want to sell prints of this model I can prepare a commercial license

Short Video:
https://www.instagram.com/reel/Dett-pbNPEl/

Check my Flexi models:
https://www.thingiverse.com/C47_3D/collections/42999523/things

Printed with 0.16 and 0.2 layer height
2-3 walls
No supports needed

May be harder to print than typical models
You will need a good bed adhesion and a good cooling
Using a glue on a bed plate is recommended

You may be needed to separate spring coils from each other after a print. Usually just with your finger nails, in some more rare cases with a hobby knife
It mostly depends on your seam settings and filament stringing
With a clean print you don't need to do anything

MULTICOLOR

Select LongDog and MULTI files (both or just Black), then drop them in slicer, merge together and select color for each part

MULTI_Black is with eyes, nose and pads
Instead of black filament you can use brown

Multicolor files are with a 'frame' that helps with models aligning
DO NOT try to 'repair' the models - frame will not be printed and it's not causing any problems with slicing

Tips if the model is breaking

Filament should be dry and with good self adhesion
Printing with wet filament will make the model more brittle (especially PLA) and model may easly break when stretched

Silk filaments (especially dual or tripple color) and the ones with particles (like 'marble') may not be a good option - but it all depends on the filament

You can try printing it slower, bonds between layers should be stronger
Lowering layer height also helps