Summary

A rebel DF.9 turret as seen in Star Wars episode V: The Empire Strikes Back

The provided STLs are in approximately 1/24 scale as I designed this to display with a studio-scale AT-ST.

Instructions

• I highly recommend that you print this on an SLA and sand the parts for good finish*
• Print one of each part, except for the df9_barrel_shroud_x2.stl which you will need 2 of.
• Sand/clean everything before assembly
• Join df9_midle to df9_base. I would recommend a 2-part 5-minute epoxy for this to give a really strong bond where you can sand out any imperfections
• Join df9_barrel to df9_top. Superglue will work fine for this
• Attach 1 df9_shroud to each side of the barrel with superglue
• df9_top can simply be dropped on top of the middle if you want to be able to pose it freely. It's heavy enough to be fine for static display. Otherwise you could epoxy it on too.