Model Overview & Print Notes
Summary
This is a spiral fidget of Dragon Egg. Consists of 14 parts. You may print it as single part or whole egg (print in place). No raft, no supports, no infill. I used 0.6 mm nozzle and only 2 walls. Layer height may be 0.2 or 0.3 mm, or variable (from 0.1 to 0.4 mm). Printing time is from 3:20 to 3:50.
Gap of parts is 0.4 mm. NOTE! You should ON the parameter "Precise wall" in your slicer. If you have the parts glued together after printing, you can try using a lower flow coefficient for the filament from 0.9 to 0.95 in the slicer. You can also carefully cut the gaps between the individual parts of the model using a stationery knife.
You can also print two eggs of different colors each, then disassemble them into separate parts and put them back together alternating colors. You can separate the parts with a stationery knife if you pull the parts apart from the inside of the bottom of the egg.
Print Settings
Printer Brand:
ELEGOO
<p class="detail-setting printer"><strong>Printer: </strong> <div><p>Elegoo Centauri Carbon</p></div></p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div></p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div></p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.6 mm nozzle, 0.3 mm height</p></div></p> <p class="detail-setting filament_material"><strong>Filament Material: </strong> <div><p>PETG</p></div></p>
💬Thingiverse Community Comments(0)
★Thingiverse Original Reviews